THE ENERGY CONSUMPTIONS AND ENVIRONMENTAL POLLUTION OF STRATIFIED CHARGE AND CONVENTIONAL SPARK IGNITION ENGINES

NOUR, HAMDY.M.

doi:10.21608/mjae.2009.107762

THE ENERGY CONSUMPTIONS AND ENVIRONMENTAL POLLUTION OF STRATIFIED CHARGE AND CONVENTIONAL SPARK IGNITION ENGINES

Document Type : Original Article

Author

HAMDY.M. NOUR

10.21608/mjae.2009.107762

Abstract

The consumed fuel energy, and the emission of exhaust gasses of stratified charge, and conventional spark ignition engines were investigated and evaluated. The comparative tests were deduced under numerous variables included the injected fuel types, compression and charge volume ratio, degree of charge stratification, engine speeds, and the time of injection.
The obtained results revealed that, replacing the stratified charge ignition engines(SCIE) instead of the conventional ignition engines(CIE), can be rationalized the energy consumption, and reduced the environmental pollution associated with the applications of stationary power sources in the Egyptian farms. Whereas, the (SCIE) engine yields reduction in NO emissions in the range of.4.21: 7.0% It is also decreased the specific fuel consumption (SFC) in the range of.8.7: 9.94% compared with the conventional injection engines(CIE).
In addition the (SCIE) engine can be operated by injecting different fuels at high compression ratios and at lean mixture without combustion problems which in turn leads to increase the thermal efficiency,
Injection of oxygen in the beginning of compression stroke enhances the engine performance and Combustion characteristics.
Stratified charge engines can be operated by injecting different fuels at high compression ratios and at lean mixture without combustion problems which in turn leads to increasing the thermal efficiency, and leads to the decrease of NO concentration emitted with the exhaust products.
Stratified charge engines can be operated at lean mixture until an equivalence ratio of 0.55, which couldn't be achieved with the conventional engines. The operation with lean mixture leads to the decrease of NO concentration emitted with the exhaust products.

Main Subjects

Agricultural Power and Machinery Engineering

References

1. Choi, S. B., and Hedrick, J. K., 2000, “ Based Controller Design Method for Improving Air/Fuel Characteristics of Spark Ignition Engines,” IEEE Trans. Control Syst. Technol., 6(3), pp. 325–334.

2. Grizzle.J.W,Julia Buckland and Jing Sun(2001),"Idle speed control of a Direct Injection Spark Ignition Stratified charge Engine "Control Systems Laboratory, Electrical Engineering and Computer Science Department, University of Michigan, Ann Arbor, MI 48109-2122, U.S.A.

3. Manzie, C., Palaniswami, M., and Watson, H., 2001, “Gaussian Networks for Fuel Injection Control,” Proc. Inst. Mech. Eng., Part D(J. Automob. Eng.), 215(10), pp. 1053–1068.

4. Manzie, C., Palaniswami, M., Ralph, D., Watson, H., and Yi, X., 2002, “Model Predictive Control of a Fuel Injection System With a Radial Basis Function Network Observer,” ASME J. Dyn. Syst. Meas. Control, 124(4), pp. 648– 658.

5. Nakazono, T. ( 1994) "Study of Lean Burn Gas Engine" JSME, vol. 37, no. 3.

6. Nakazono, T. and Natsume, Y. ( 1994) "Effect of Dimensions of Pre- chamber on Lean Burn Gas Engine" JSME, vol. 37, no. 4.